Run it over

Today I ran over my photos.

I taped a negative print of three images, and one devoloped image to one of the rear tyres of my car. I reversed a few metres and then drove forward to my original position.

This is what happened.

 When the car drove over the negative print it was torn into three pieces. It is not very strong or maleable. Here we can see marks of dust where the car was pushing the negative into the dirt. The lines are caused by lines of space in the tyre.


 
You can see more of the cracking and scrathing of the negative on this side and less of the dust print.
 























I am unsure of what happened in the two above images when scanning them. On the left is the back side of the printed image, on the right is the printed image s front side.




Next I taped a negative to the wheel of a bike and the developed image on the other wheel

This is what happened.

Here we see the negative and some of the texture that the bike gave it.

Here we can see the otherside of the film where there is dust marks where the bike tyres have been put under weight in this point.



















Again I am unsure as to what happened on the developed photos on scanning, however in the second image you can clearly see a tyre mark.